Vaping has been one of the most known methods of consuming marijuana. In order to start vaping, you need to extract and get the oil on it. However, these oils are sometimes not readily accessible at your local drugstores and marijuana dispensaries. That is why you are forced upon to make these oils as needed.
Likewise, the process of making marijuana weed oil is really very easy. This article will provide you startups and steps on preparing marijuana weed oil.
Gathering of Materials and Tools to Make Weed Oil
These are some of the important tools and materials that you should acquire to make marijuana weed oil. This includes the following;
About 5-6 grams of high-quality, pure, and finely chopped weed
2-4 ounces of 180 proof+ grain alcohol (for flavor neutrality; most favorable-vodka; no rubbing alcohol )
Two large mason jars
Pyrex Bowl (aluminum foil or baking sheet)
Decarboxylation (Activating the THC)
Place your weeds in a pyrex bowl or an aluminum foil then bake it into an oven for 225-250°C for 15 minutes. Upon taking the bowl, weeds should be fully crisp.
The weed should be put in a mason jar and then, pour the high-grade alcohol. The alcohol should be enough to submerge the weed.
In a separate pot, add about 3.5-4 inches of water from it. Place the jar in the pot and then, heat the pot to low boiling. Stir the solution until the weed gets dark. After then, you could remove the pot from the stove.
Weed Oil Filtration
Get a clean cheesecloth and use it to cover into a separate mason jar.
Slowly pour the weed solution from the first mason jar into the second jar. Use a knife or a fork to transfer it.
Squeeze the cheesecloth into the second mason jar. The jar should be filled with dark brown liquid. For efficiency, let the straining stand for minutes until the cheesecloth won’t drop a single liquid.
Unfortunately this doesn’t filter out any of the many chemicals found in cannabis that may have been used to grow the plant. Using marijuana grown from your own cannabis seeds is always the best (and most rewarding) way to use cannabis.
Weed Oil Processing
Put the mason jar with marijuana liquid extracts into the pot with water. Heat it until about 5 mL of the extract is left in the mason jar.
Remove the pot from the stove and use a syringe to get 5 mL of extract into the jar. Transfer it into another separate jar.
Add 20 mg of propylene glycol into the third jar and store it accordingly before using it.
You can also make your own shatter dabs using a slightly different process. Both are a rewarding and fun way to enjoy smoking marijuana.